19
LSF-1010 (EN)
DEUTSCH
FRANÇAIS ESPAÑOL
NEDERLANDS ITALIANO
Other Ways to Set Up the Satellite Speakers
Wall Mount
You can mount the satellite speaker stands on the wall as described below.
Precautions
Please observe the following precautions when mounting speaker stands onto
the wall.
• Be sure that the wall you are using is strong enough to support the full
weight of the speaker and stand (approx. 650 g [1.4 lb]).
• Wall screws must be purchased separately. Be sure to use screws that are
appropriate for the wall you are using, and that are long enough to pro-
vide sufficient strength.
• If you are uncertain about the wall’s support strength, the type of screw to
use, or any other points regarding this type of installation, please consult
a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation.
Kenwood can assume no liability for injury or damage that may occur if a
speaker setup falls from the wall as a result of incorrect installation or insuffi-
cient support strength.
For information about how to remove/replace the screw caps and loosen the arm
screws, see page 16, “Getting Ready to Adjust.”
1. Remove the arm.
1Loosen the two arm screws and pull
the arm out.
• Unplug the cord from the jack before
removing the arm.
• Be sure to remove the clip from the
pole before proceeding to mount the
stand onto the wall. The clip may be-
come stressed or damaged if left in
place during the next few steps.
2Loosen the two arm screws further to
remove them from the arm holders.

2. Set the arm holders to the desired angle.

1Take one of the arm holders, rotate it
to the desired angle, and place it back
into the opening.
2Loosely fasten the holder in place with
the arm screw.
• Donít tighten the screw all the way.
Tighten only enough so that the arm
holder stays in position at the selected
angle.
3Now set the other arm holder (the
holder on the other side) to the same
angle, and loosely fasten it place with
the arm screw.

3. Attach speaker cord to the base.

1 Connect the included speaker cord.
Loosen the screws.
Remove the screws from the arm holders.
Arm holders
Use a coin or
screwdriver to turn
loosen the screws.
Remove the plastic
insulation from
each wire tip, and
twist the exposed
metal wire.
Be sure that the screw
head makes contact
with metal only, not
with plastic insulation.
Curl the wire around
the thin part of the
corresponding screw,
and then tighten the
screw.
White
stripe