LSF-1010 (EN)
24
DEUTSCH FRANÇAIS
ESPAÑOL ITALIANO NEDERLANDS
If the subwoofer does not seem to be working correctly, the following advice may help you correct the problem.
Troubleshooting
Volume is too low. * Speaker cords are reversed.
* The phase setting is not appropriate.
* The amp or receiver's PRE-OUT level is set to the minimum.
(Applies only if your amp or receiver includes a pre-out level
adjustment.)
Possible Cause
No sound.
See page...
*Connect the wires securely. (Refer to "Making Connections.")
*Raise the volume to an appropriate level.
* Switch on the SUBWOOFER PRE-OUT signal at the amp or
receiver.
* Wires are not securely connected.
* The volume is turned all the way down.
* The amp or receiver's SUBWOOFER PRE-OUT signal is switched
off. (Applies only if your amp or receiver includes a pre-out on/
off switch.)
Problem Correction
* Reconnect so that L, R, (+), and (–) connections are correct.
(Refer to "Making Connections.")
* Change the setting of the PHASE switch.
* Raise the PRE-OUT level at the amp or receiver.
10
14
10
14
7
Noise in AM reception. * The subwoofer is placed too close to the AM receiver. * Move the subwoofer from the AM receiver.