Kenwood MD-R2 APMS Automatic Programmable Music Selector, Continued, To cancel the APMS

(Continued)

PROGRAM DELETE/CLEAR

TIMER

1 2 3 4

5 6 7 8

9 10/0 10

PROGRAM

CLEAR

1

PRGM

“PRGM” indicator

2

	TOTAL		2
	PRGM
3	TOTAL		2	3	6
		8	9
	PRGM
	Total playing	Selected track
	time	number
4			2	3	6
		8	9
	PRGM

1 2 3 4 5 6 7 8 9 1011121314 151617181920

“PRGM” will disappear.

	2	3	6
8	9

PRGM

The playing time will appear about 2 seconds later.

■APMS

(Automatic Programmable Music Selector)

1 Press the PROGRAM button while in the stop mode.

●Programs cannot be set or canceled while in the playback or pause mode.

2 Select a desired track number by pressing the DIRECT KEY button on the remote control.

●Repeat steps 1 and 2 for any track. Up to 20 tracks can be programmed.

●If the total program playing time exceeds 199 minutes and 59 seconds, “— : —” will appear. However, the programmed selections will still be memorized.

3 Press the ■ button.

4 Press the 06 button to start playback of the programmed selections.

●After all of the programmed tracks have finished playing, the unit will automatically stop.

To clear the programmed selections:

Press the DELETE/CLEAR (CLEAR) button while the “PRGM” indicator is flashing.

●Each time the button is pressed, one track will be cleared, beginning with the last track programmed.

To cancel the APMS:

While the unit is stopped in the APMS mode, press the CLEAR button on the remote control to turn off “PRGM”.

When you use the DELETE/CLEAR button on the main unit, all of the programmed contents will be erased by holding it down for at least 2 seconds. (If you simply press this button briefly, the unit will enter the timer mode.)

●The program contents will be erased.

●If a MiniDisc is removed or when the unit enters the recording standby mode, the APMS mode will be canceled.

To check which tracks are programmed:

While the unit is stopped in the APMS mode, turn the jog dial. Or press the 5 or 4 button on the remote control.

●When the jog dial is turned clockwise, the next track number will appear. When it is turned counterclockwise, the previous track number will appear.

To add tracks to the APMS:

When a program has been entered ("PRGM" will be lit), perform steps 1 - 4. Additional tracks can be selected and they will be stored after the last track you entered.

Note:

●It is not possible to insert an additional track between programmed tracks that have already been entered.

13

MD-R2