(Continued)
■If a problem occurs
If this unit functions abnormally during operation, first check the following items. If the unit continues to function abnormally, or if an abnormality appears other than listed below, turn off the player's power and disconnect the AC power plug, then consult your SHARP dealer or service personnel.
General
SYMPTOM | POSSIBLE CAUSE | REMEDY | ||
|
|
|
|
|
The clock is wrong. | Did a power failure occur? | Try setting it again. | ||
|
|
|
|
|
When a button is pressed, the unit |
|
|
| Turn the power off and on again, and |
does not respond. |
|
|
| then retry the operation. |
|
|
| ||
|
|
|
|
|
Radios make unusual noise or the pic- | When a radio or TV which uses an | It is recommended that you use an | ||
ture on the TV screen is distorted. | indoor antenna is placed near the | outdoor antenna. | ||
| unit, the picture on the TV screen may |
| ||
| be distorted or the radio may not func- |
| ||
| tion properly. |
| ||
|
|
|
|
|
Audio
SYMPTOM | POSSIBLE CAUSE | REMEDY |
A recording cannot be made. | Is the MiniDisc protected against ac- | Slide the accidental erase prevention |
| cidental erasure? | tab back to its original position. |
| Did you try to make recording on a | Replace it with a recordable disc. |
|
| |
| Can you see the “TOC FULL” mes- Put in another recordable disc with | |
| sage in the display? | recording space on it. |
|
|
|
Even though a disc has been loaded, | Is the disc scratched? | Replace the disc. |
“no disc” or “Error” is displayed. | Is the unit located near excessive | Place the unit on a firm, level surface |
| vibrations? | free from vibration. |
|
|
|
Playback stops in the middle of a | Is the unit located near excessive | Place the unit on a firm, level surface |
track, or playback is not performed | vibrations? | free from vibration. |
properly. |
|
|
Playback sounds are skipped. | Has condensation formed inside the |
| unit? |
Remove the disc and leave the power turned on. The unit should function properly in about 1 hour.
Remote control
SYMPTOM | POSSIBLE CAUSE | REMEDY |
|
|
|
The remote control does not function | The batteries (polarity) are not inserted | Insert properly. |
or does not operate properly. | properly. |
|
|
|
|
| The batteries inside the remote control | Replace the batteries. |
| are dead. |
|
|
|
|
| The remote control is operated from | Operate it within a range of 8" (0.2 m) |
| an incorrect distance or angle. | to 20' (6 m) and within an angle of 15o |
|
| to either side of center. |
|
|
|
| No disc has been loaded. | Load a disc. |
|
|
|
The power cannot be turned on from | Is the AC power cord plugged in? | Connect the AC power cord. |
the remote control. |
|
|
|
|
|
| 36 |
|