Kenwood TS-480 manual Fsk

CW	33	Keying priority over playback	Without switching off the repeat
			playback for messages, you can start
			keying.
	34	CW RX pitch / TX sidetone	Select RX pitch frequency between
		frequency	400Hz and 1000Hz. At the same time,
			sidetone frequency changes with the
			pitch frequency. This can be used to
			zero in on a target signal by matching
			the sidetone frequency with the RX
			beat.
	35	CW keying weight ratio	Change the dot/dash weight ratio. This
			is usually set to AUTO.
	36	Reverse CW keying auto	You can change the AUTO setting for
		weight ratio	#35.
	37	Bug key function	Manual TX can be enabled for dashes
			only.
	38	Swap dot & dash paddle	Swap the paddle position to suit either
		position	right-handed or left-handed use.
	39	Auto CW TX in SSB mode	Automatically switch mode to CW
			transmission by simply operating the
			paddle.
	40	Define CW tune frequency	Useful if used in combination with #39,
			as there is no need to operate the dial
			to zero in on a target.
FSK	41	FSK shift	Standard FSK operating parameters
			are covered by these menus.
	42	FSK keying polarity
	43	FSK tone frequency
FM	44	Mic gain for FM	You can adjust FM mic gain (3 levels)
Data	45	Filter bandwidth for data	This enables you to pick the
communicat		communications	appropriate DSP filter for data
			communications using the filter switch
ions
			on the control panel.
	46	AF input level for data	Adjust input and output levels
		connector	independently when the TS-480 is
			connected to a SoundBlaster™ card or
	47	AF output level for data
			other external device.
		connector

32