Kenwood VR-509 Restoring the original factory settings, Storing on the memory, Remote control operations, To operate other components, To delete the stored memory

5From the remote control unit of the other source, press the key

38	that you want to store.
	• The remote code is sent to the remote control unit.
	• “Complete” appears when finished.
	Complete
	>Extend1
	• When it takes for more than 5 seconds or the remote control unit does
	not receive the remote control code well, “Error” appears in the
	display. In this case, re-operate from step 1.

6The remote control code is stored on the key of the remote control unit.

To delete the memory stored on the key

Press the display operation 1 [Clr] key in step 4. “Cleared” appears in the display.

The memory previously stored is cleared.

To operate other components

1Press the MUSIC, MOVIE, or TV key to select the desired input source.

2Press the desired key.

Storing on the memory

You can store on the remote control unit up to 5 memories.

1Point the infrared ray system part of the other remote control unit to the remote sensor of the remote control unit .

+ —	Remote control
	unit of the other
+ —	source.

Infrared ray system part

2Press the MUSIC, MOVIE, or TV key to select the input of the desired remote control unit.

Remote		Video1:
		VCR
		Menu
Control	Selected input
	3 Press the LEARN key.
	• The Extend selecting display appears.
	When the setup code is registered
		>Extend1
		>Extend2
		Home Enter
	• When the setup code is not registered, any messages do not appear.
	4 Press the 5/∞ keys to select the location.
	• Extend1 – Extend5 are available.
	5 Press the display operation 2 [Enter] key.
	• The remote control is sent for receiving the remote control code.
		Waiting
		>Extend1
		Clr Exit

Remote control operations

6From the remote control unit of the other source, press the key that you want to store.

•The remote code is sent to the remote control unit.

•“Complete” appears when finished.

Complete >Extend1 Extend 1

•When it takes for more than 5 seconds or the remote control unit does not receive the remote control code well, “Error” appears in the display. In this case, start from the step 1 again.

7The remote control code is stored on the memory (Extend1 – Extend5) of the remote control unit.

To delete the stored memory

Press the display operation 1 [Clr] key in step 5. “Cleared” appears in the display and the memory that is selected in step 4 is erased.

To operate other components by using the stored memory

1Press the MUSIC, MOVIE, or TV key to select desired input source.

2Press the display operation 2 [MENU] key during “Menu” appear in the display.

•The Menu display appears.

3Press the 5/∞ keys to select the memory you want to operate.

4Press the display operation 2 [Enter] key.

Restoring the original factory settings

You can restore the setup codes or memories to their original default settings.

5

2

Insert the batteries while pressing and holding the 5 key and 2 key.

•“Cleared” appears in the display, and the remote settings return to their original default settings.

•To maintain the memory settings, complete the battery replacement operation approximately within 10 minutes.