F | Contrôle du |
Check operation | fonctionnement |
Check that all parts have been installed (except access and lower panels) and no steps were skipped.
Check that you have all the tools you used.
Read the Use and Care Guide that came with your dishwasher.
Reconnect power supply to dishwasher. Set the dishwasher to run the “Normal” cycle. Start dishwasher and allow it to run for 2 minutes. Open dishwasher door. The water level should be deep enough to cause the float (A) to float on the water. If the water level is correct, close the door and allow the dishwasher to complete the cycle.
If the dishwasher does not fill to the proper level, check the following:
• Is the shutoff valve in the water supply line completely open?
• Is the water supply line blocked or kinked?
A | Check that there are no water leaks. If there are water leaks, | |
tighten fittings. | ||
|
Reattach access and lower panel to dishwasher so that the bottom edge of the lower panel contacts the floor.
Your installation is now complete.
Keep Installation Instructions and Use and Care Guide
close to dishwasher for easy reference.
Vérifier que toutes les pièces ont été installées (sauf le panneau inférieur et le panneau de l’ouverture d’accès) et qu’aucune étape n’a été omise.
Vérifier la présence de tous les outils utilisés.
Lire le Guide d’utilisation et d’entretien fourni avec le
Rétablir l’alimentation du circuit électrique du
Si le
•Que la soupape d'arrêt dans la canalisation d'alimentation d'eau est complètement ouverte.
•Que la canalisation d'alimentation d'eau n'est pas bloque ou écrasée.
S'assurer qu'il n'y a pas de fuite d'eau. En cas de fuite, resserrer les raccords.
Réinstaller le panneau inférieur et le panneau de l’ouverture d’accès du
L’installation est maintenant terminée.
Conserver les instructions d’installation et le Guide d’utilisation et d’entretien en lieu sûr, pour pouvoir facilement les consulter.
11