KitchenAid KUD-22 manual I Choosing The Loca T/On, I- ‘1 337/,6” thru 35” ‘I 849-889 mm

I CHOOSING THE LOCA T/ON

For easy access to plumbing, it is most convement to have your dishwasher located near the kitchen sink.

Any built-in dishwasher must be fully enclosed on the top, both sides, and the back. Therefore, the cabinet space below your kitchen counter is probably the best location. If the dishwasher is being installed at the end of a cabinet or free standing then side panels and a wood top can be purchased from your KitchenAid dealer to enclose the dishwasher.

The cabinet opening (Fig. 1) should be square with dimensions as follows: Height - 3311/,6” (856 mm) to 35” (889 mm); Width - 24” (610 mm) minimum; Depth - 24” (610 mm) minimum. If the dishwasher height of 33”/ ,6” (856 mm) is too high, it may be reduced to 337h6” (849 mm) by removing the leveling feet. If side panels are used, cabinet height should be 34%” (876 mm) minimum to 35” maximum using the adjusting legs.

) 0
	I
.i[	1
p.	I	DISHWASHER	COUNTERTOP
.D *

I- ‘1 337/,6” thru 35”

‘I (849-889 mm)

I-Clearance for door openmg 1 2” (51 mm) minimum

3

Fig. 2

If the drshwasher IS installed in a corner, there must be adequate clearance to open the door (Fig. 2)

ITo protect against possible water lines in the dishwasher the warranty.

rupture of the fill valve, water lines leading to the dishwasher, as well as MUST be protected against freezing. Such ruptures are not covered by

I

-5-