REAR CROSS CHANNEL ADJUSTMENT
Slide the dishwasher into the cabinet opening, being careful to avoid damage to the floor or interference with water, drain, and electrical lines. DO NOT remove the rear cross channel, unless there is an interference with the plumbing lines. In most cases, any plumbing interference can be eliminated by raising one side of the rear cross channel. (See Fig. 10 for details.)
Back of dlshwasher
Rear cross channel
I” alternate pos~llon
SteD Looser
lhls SC’YW _
SleD Remove
lhls screw. _
Fig. 10a
Line up the lower cross channel hole with ihe upper hole in frame
Fasten securely Tighten the
.screw at other end.
-Step 1 ~ Remove
these screw’ s.
cross channel lglnal posltlon
Unlatch and open the door and remove the foam shipping cushions from uppelr corners of the door. Check to ensure that cabinet clearance is equal on both sides of the dishwasher and that cabinet interference does not distort dishwasher tank.
With the door still open, place a spirit/bubble level against the front tank flange (Fig. 11) and level the dishwasher
Adjustable bracket in shlpolng posltlon
>
Fig. 11
If the dishwasher is not properly leveled or if it is distorted by cabinet interference, the door may not seal properly and may leak. If necessary, the leveling leg may be further adjusted to correct any distortion and align tank for equal clearance on both sides (Fig. 12).
