![](/images/new-backgrounds/1059671/5967135x1.webp)
Optional Stand Mixer Accessories
(Accessories not NSF Approved for KSMC50)
General Information
KitchenAid® Accessories are designed to assure long life. The Accessory power shaft and hub socket are of a square design, to eliminate any possibility of slipping during the transmission of power to the Accessory. The hub and shaft housing are tapered to assure a snug fit, even after prolonged use and wear. KitchenAid® Accessories require no extra power unit to operate them; the power unit is built in.
Accessory Hub
Accessory |
Hub Socket |
Accessory
Knob Accessory Power
Shaft‡
®
Mounting Accessory
1.Turn mixer off and unplug.
2.Loosen Accessory Knob by turning it counterclockwise.
3.Remove Accessory Hub Cover.
4.Insert Accessory shaft housing into Accessory hub, making certain that Accessory power shaft fits into square Accessory hub socket. It may be necessary to rotate Accessory back and forth. When Accessory is in proper position, the pin on the Accessory will fit into the notch on the hub rim.
5.Tighten Accessory knob by turning clockwise until Accessory is completely secured to mixer.
6.Plug mixer in proper electrical outlet (see page 4).
Notch Pin
Accessory Shaft
Housing‡
‡Not part of mixer.
Removing Accessory
1.Turn mixer off and unplug.
2.Loosen Accessory Knob by turning it counterclockwise. Rotate Accessory slightly back and forth while pulling out.
3.Replace Accessory Hub Cover. Tighten Accessory Knob by turning it clockwise.
16