1.If necessary, attach two rubber stands (provided) with two (4x8 mm) screws (provided) to the back of the hood.
2.Using references on Table 2 and measurement on page 16, decide the leveling point of the hood. Position two mounting screws (not provided) on the wall, leaving 1/8” away from the wall as shown on Figure 11.
3.Align
Hood-
Mounting
Bracket
Figure 10
Mounting
Screws
Figure 11
Duct Cover Installation
4.Mark the position of the duct
5.Connect electrical wires. Refer to “Wiring to Power Supply.” If necessary to hide the electrical wire connections, push wires back into the hood. Access the wire connections underneath the hood by removing the bottom casing from the six screws. Before reattaching the bottom casing, make sure wires do not slip between motors, impellers, or any moving parts to prevent any damage.
6.Use aluminum or steel pipe to connect the exhaust opening on the hood to the ductwork above. Use duct tape to make all joints secure and air tight.
7.Slide the inner duct cover up
Figure 12 | Figure 13 |
8.Adjust the height of the inner duct cover to the duct
9.Fasten outer duct cover to plastic plate on the hood with four (4x8 mm) screws (provided).
9