Cintel International Ltd. | diTTo User Guide |
Lacing film
Always scan the film with Emulsion up (towards camera lens). Focus will be compromised if film is laced emulsion down.
Ensure gate is in “Lace position” as shown in Fig 36. The Latch will push in to keep the gate in lace mode.
Lace Position | Fig 36 | Loaded Position |
1.Lace Film left to right missing the feed and take up sprockets and run the film straight from the Feed Compliance arm to the Take Up compliance arm via the PTR (Particle Transfer Roller) rollers to the take up film core. Lace as A or B wind depending on the wind direction of the supplied film rolls.(See Fig 34).
A or B status is set on the GUI (see page 7). Wind sufficient film onto the
Fig. 37 Initial lacing path
2Lace Take Up Sprocket. Rotate hold down clamp to lift
hold down rollers away from the sprocket as shown in Fig 38. Wrap film around sprocket as indicated, ensuring film perforations engage with sprocket teeth. When correctly wrapped rotate hold down clamp to lower rollers onto film.
3Lace film temporarily through gate, leaving sufficient loop for film motion.. The loop lengths should be set so they are just touching the skid plate area of the gate. (See Fig 37/38)
Fig 38 Sprocket lacing path
Issue 3 | 22 |
