Kodak 3 manual Saftey Precautions and FCC Compliance, Appendix Masking

Cintel International Ltd. diTTo User Guide

Appendix 3 Safety information relating to Keykode reader. (DATALOGIC USS Scanner)

SAFTEY PRECAUTIONS and FCC COMPLIANCE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference which may cause undesired operation

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause harmful interference to radiocommunications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct this interference at his own expense. 851000173 (Rev C)

The following information is provided to comply with the rules imposed by international authorities.

STANDARD LASER SAFETY REGULATIONS

This scanner conforms to the applicable requirements of both CDRH 21 CFR 1040 and EN60825-1 at the date of manufacture.

CAUTION

Use of controls or adjustments or performance of procedures other than those specified herein may result in exposure to hazardous visible laser light.

The laser light is visible to the human eye and is emitted from the window indicated at figure A in the relative installation manual and the orange window shown in Fig 41 page 25 in this manual.

This product utilises a low-power laser diode. Although staring directly at the laser beam momentarily causes no known biological damage, avoid staring at the beam as one would with any very strong light source, such as the sun. Avoid that the laser beam hits the eye of an observer, even through reflective surfaces such as mirrors etc.

Laser warning and classification labels are placed on the product and reproduced in the installation manual.

Label contents: LASER LIGHT

DO NOT STARE INTO BEAM

CLASS 2 LASER PRODUCT

MAX. OUTPUT RADIATION;

EMITTED RADIATION;

TO EN60825-1 (200

_________________________________________________________________________________________________

Appendix 4 Masking

The term masking, as used in film scanning devices, has a different meaning to that used in the film production and post production industry. Masking in the context of film scanning is NOT a means of keying certain parts of an image for special effects or image compilation.

The Masking control provides the ability to individually adjust the ‘masking’ of the Red Green and Blue signals by adding or subtracting Red, Green and Blue information.

Masking is used to match colorimetric balances due to the variations in the taking characteristics of colour film stock. Masking should generally be used only to compensate for such variations. It should not be used as a means of general colour correction.

__________________________________________________________________________________________

Issue 3 36