4.While holding the cleaning card in place, select Scan from the Kodak ScanTest Software window allowing the entry rollers to scrub the card.
5.Wait until the motor stops, then remove the card, observing the dirt and flip the card to a clean corner and repeat Step 4.
To clean the remaining drive rollers:
6.Place the cleaning card in the input tray and select Scan. You may need to give the cleaning card a slight push to start it through the transport.
7.Turn the cleaning card over and repeat Step 6.
8.Scan the cleaning card three or four more times. Be sure that you continue to turn the cleaning card to a clean side each time you scan the cleaning card through the transport. Steps 6 through 8 remove the residual dirt on the four drive rollers.
9.When finished, discard the cleaning card and shut down the Kodak ScanTest Software.
24 |
|
