Kohler K-3900 manual Install the Remote Dock, Disconnect, 1132336-2-D, Kohler Co

Rear
Plate	Front Plate

Holes

Back Cord

Opening

Disconnect.

Screw

Orange

Blue

Red

White

Black

Back Cord

Opening

Docking	Connector	Bottom Cord
Cord	Harness	Opening

1. Install the Remote Dock

NOTE: The docking station comes with a 15’ (4.6 m) cord. Locate the docking station to allow the docking cord to reach the toilet.

Unpack the box containing the remote control components.

Remove the remote control from the dock and set aside.

Remove the small screw on the bottom of the docking station.

Carefully remove the cover plate by gently prying the sides of the cover plate out until they disconnect from the dock.

Carefully disconnect the cover plate plug.

Tape the screw to the cover plate and set it aside.

NOTE: When the docking station cord is routed externally through the wall, it may be easier to use the back cord opening. When the cord is routed externally along the face of the wall, use the bottom cord opening.

For installations using the back cord opening, route the power cord through the back cord opening.

For installations using the bottom cord opening, route the power cord through the bottom cord opening.

Position the docking station in the installation position and mark the screw locations using the dock as a template.

Drill appropriate size mounting holes at the screw mounting locations. The size of the hole will depend on the need for wall anchors, wall material, and installation requirements.

Loosen each of the five small screws located where the wires will be connected.

Run the power cord into the docking station.

1132336-2-D 10 Kohler Co.