Kohler K-3900 Install the Toilet, Position the Toilet, Check for Leaks, 1132336-2-D, Kohler Co

	External	FM Antenna
	Speaker
		Connection
	Connections
Wall Supply		Docking
Installation		Station
Shown		Cord

Docking
Station
Cord	Bushing
	Cap
	Screw

5. Install the Toilet

Position the Toilet

Carefully lower the toilet into place, making sure the water supply line and electrical cord do not interfere with the toilet when it is in place.

Connect the water supply hose to the supply stop.

Connect the docking station power cord.

Connect the optional external FM antenna (not shown) to the toilet if needed.

Connect the external speaker wires (not shown) to the toilet if external speakers are installed.

IMPORTANT! The remote control will not function when removed from the docking station until it has charged for approximately 30 minutes. Flush the toilet manually or use the remote control while it is attached to the docking station using the buttons on the toilet until the remote control is fully charged.

Place the remote control on the docking station.

Turn on the water supply.

Connect the power.

Check for Leaks

NOTE: Once the power is connected, the toilet will automatically enter start-up mode. This process takes several minutes.

NOTE: If there is a failure during start-up mode, follow the directions on the remote control.

Once the start-up sequence has been completed flush the toilet using the manual buttons on the side of the toilet.

1132336-2-D 16 Kohler Co.