Kohler K-3900 manual Front of Bowl, Kohler Co, 1132336-2-D

	29-1/2" (749 mm)				Front of Bowl
	3-3/4" (95 mm),
					10-13/16" (275 mm)
	3-9/16" (90 mm) Min
							4-3/4" (121 mm)
Optional			14-1/2"				Ø 2-5/8"
			(368 mm) Optional Supply
Supply,							(67 mm)
1/2" OD				1/2" OD Compression
Compression	25-3/4"			Outlet Thread			25-1/4"
Outlet Thread							(641 mm)
	(654 mm)
				13-5/8"
	38" (965 mm) - 66" (1676 mm)						12"	Finished
				(346 mm)			(305 mm)	Wall
		5-15/16"	Docking Station
1-3/4"		(151 mm)
							Power Cord
(44 mm),		4-1/16" 2-1/4"
1-1/2"							Reaches
(38 mm)		(104 mm) (57 mm)					56" (1422 mm)
Min			41" (1041 mm) -		1/2" OD
36-1/4"
			66" (1676 mm)		Compression		17-7/8"
(921 mm)					Outlet Thread
			15-5/8"				(454 mm)
			(397 mm)		6"
					(152 mm)		Outlet
12" (305 mm)		C				8" (203 mm) 2" (51 mm)
		L Of Outlet

Roughing-in - Wall Mount Electrical and Water Supply

WARNING: Risk of electric shock. Disconnect power before servicing.

WARNING: Risk of electrical shock. For plug-in installations/wall-mounted electrical supply: Connect only to a properly-grounded,grounding-type receptacle which is protected by a Ground-FaultCircuit-Interrupter (GFCI) or Residual Current Device (RCD). Do not remove the grounding pin or use a grounding adapter.

NOTICE: The locations for the supply shut-off, electrical outlet, and docking station cord are suggested locations. Make sure all installations adhere to applicable codes and standards.

IMPORTANT! Locating the supply stop behind the toilet will make it difficult to remove the back panel. It may be necessary to remove the toilet to service items behind the back panel if the supply stop extends more than 3″ (76 mm) from the wall.

IMPORTANT! Do not install any items behind the toilet that will interfere with the cover when it is raised. All decorative items should be at least 37″ (940 mm) high to allow clearance for the cover.

The remote docking station is equipped with a 15’ (4.5 m) power cord. The station mounting location shown for the docking station is ADA compliant.

The supplied power cord is 56″ (1422 mm) in length. Install the GFCI or RCD protected outlet within 56″ (1422 mm) of the toilet location.

The toilet is equipped with a motion sensor to automatically open the cover when movement is sensed. This sensor has a maximum range of 51-1/2″ (1300 mm). Sensitivity can be adjusted or turned off using the User Interface.

The toilet is equipped with a sensor to automatically open the seat when the light is interrupted. The sensor is located on the right side of the toilet. This sensor has a maximum range of 8″ (203 mm). Keep this area free of obstructions.

Kohler Co. 5 1132336-2-D