On the selected date the alarm tone of the RDS Radio Alarm reminds you of the programmed appointment. The reminder sounds hourly between 08:00 and 23:00. Thereby, the alarm tone remains switched on for 10 minutes.
To interrupt the alarm tone: Press any button. The alarm tone sounds again on the next full hour (and each following full hour on this day).
To programme additional appointment remind- ers:
Follow the steps 1 to 8 in this chapter. However, before carrying out step 2 press once on …
Úthe button “2/7” K, to select the second memory slot (“SDA2”) for appointments.
Úthe button “3/8” J, to select the third memory slot (“SDA3”) for appointments.
Úthe button “4/9” H, to select the fourth memory slot (“SDA4”) for appointments.
Úthe button “0/5” ;, to select the fifth mem- ory slot (“SDA0”) for appointments.
The individually selected memory slot then blinks in rotation with the date indicator
Subsequently, contine with further steps as described.
8.3.3 Programming the Nap Timer
With the so called “Nap Timer” you can arrange an alarm call after a short pause or a reminder for an appointment. You can pro- gramme time periods between 0 and 120 minutes until switch on of the reminder alarm. To programme the Nap Timer:
1Press the “NAP Timer” button T once. In the display D “NAP” and “60” are blinking.
2Programme the desired time interval until activation of the reminder alarm. Time in- tervals between 0 and 120 minutes are avail-
able. To do this, press the buttons | O | |
resp. | A. With each press of the buttons | |
you increase or decrease the indicated time- span by ten minutes.
3Press the button “NAP Timer” T once more to confirm the programming.
The reminder alarm call sounds when the selected timespan has elapsed. The time remain- ing to the reminder alarm call and “NAP” are shown in the display D. Until switch on of the reminder alarm call the operational state display
Wblinks.
4To switch off the Nap Timer: Hold the button “NAP Timer” T pressed down; “NAP” and the indicator for the timespan in the display D extinguish.
9.Adjusting the display brightness
The brightness of the display D can be adjusted in two levels. This functions with both a switched on and a switched off radio. For this:
1Hold the button “SNOOZE” E pressed for ca. three seconds, until the display bright- ness has diminished.
2To raise the display brightness again: Once again hold the button “SNOOZE” E pressed down for ca. three seconds.
