- 23-
14. Troubleshooting
The display is blank/DVD player does not function, even
though it was switched on
ACheck whether the power cord is properly plugged into
the socket.
BCheck whether the socket into which you have plugged
the power cord of the DVD player is supplying electricity
by plugging in another device. Where appropiate plug
the DVD players power cable into another power socket.
CCheck to see that the display dimmer function is switched
off. For this purpose press the button "Dimmer" on the
remote control.
DSwitch the DVD player off by pressing the ON/OFF button
and then wait ten seconds. Switch the DVD player on again
by pressing the ON/OFF button once more.
The display indicates "No Disc", even though a disc was inserted
AThe disc is dirty, scratched or damaged. Clean the disc or insert a
different disc.
BThe Country/Regional code of the inserted DVD/VCD/
S-VCD does not coincide with the Country/Regional code
of the DVD player. In this case, the DVD/VCD/S-VCD cannot
be played with the DVD player.
Inserted disc is not played
A film of condensation may have formed on the laser sensor
lens of the DVD player. In particular, this may occur if the
DVD player has been subjected to extreem temperature fluc-
tuations.
In this case, place the DVD player in a dry environment at
normal room temperature. First remove any inserted disc
from the disc tray. Then leave the DVD player switched off for
at least one hour without using it until the condensation film
has evaporated.
No image or only black and white image
ACheck to see that all connection cables between the DVD
player and television (or Video projector) are plugged
firmly into the corresponding sockets
BCheck whether the settings in the OSD menu match the
connection option you have used to connect the DVD
player to the television (or the video projector).
ÔFor this refer to chapter 6 "Connection of the DVD player
to a television".
CUsing the television's (or Video projector's) instruction
manual check to see if current settings to the television
(or Video projector) are necessary in order to use the
DVD player with the television.
No sound
ACheck to see if the television and/or DVD player are
currently switched to mute.
BCheck to see if all connections cables between the DVD
player and currently connected audio components are
firmly plugged into the corresponding sockets.
CCheck whether the settings in the OSD menu match the
connection option you have used to connect the audio
components to the DVD player.
ÔFor this refer to chapter 7 "Connecting Audio components
to the DVD player.
DUsing the television's instruction manual check to see if
current settings to the television are necessary in order
to use the DVD player with the television.
EUsing the instructions manual of a currently connected
audio component check to see if settings to the compo-
nent are necessary in order to use it with the DVD player.
FIf you …
Úhave connected the DVD player to a stereo television and
have not connected an audio component to the DVD player
or
Úhave connected a Dolby Prologic compatible audio compo-
nent via the analogue stereo outlet (via cinch cables to the
cinch sockets L and R) of the DVD player:
Check to see if you have selected the option Large in the
OSD Menu under the Sub menu option Front LS.
No 4:3 or 16:9 image
AConsult the operating manual of the television to determine
which image format the television supports.
BCheck whether the settings in the OSD menu match the
available image format of the television.
Remote control does not function
ACheck to see that the remote control batteries are inser-
ted into the battery compartment according to the correct
polarity.
BCheck whether the batteries in the remote control are
dead and replace both batteries, if necessary.
KH 6510/6511
KH6510_11_A4_V3_EN.qxd 24.08.2006 12:25 Uhr Seite 23