1. Advice on Installation and User Safety
1.2 Installation
An inadequate location of the system can lead to a loss in copy quality and can even damage the equipment. The following should therefore be considered before installing the unit. Also see 1.3 Installation Space for the minimum space requirements of Konica 7020.
1. The location of the equipment must be level and must not be subject to vibration.
2. The unit should only be installed in surroundings which are dry, clean and well ventilated.
3. The equipment and its exclusive power outlet must be easily accessible and not be obstructed in any way.
4.Only connect the unit to a tested socket which is approved by the local electricity board. Ensure that neither the socket nor the connecting lead are damaged in any way. Do not use any extension lead or branched socket.
5.The unit is intended for use in temperatures between 10° and max. 30° Celsius as well as humidity between 10% and max. 80%. Avoid installing this equipment in locations with greatly varying temperatures (close to heating or window) as well as direct sunlight.
6.When in use ozone is generated by this equipment, however in small, not hazardous amounts. An odour may be detected after long periods of use in a poorly ventilated room. This can be avoided by adequate ventilation at regular intervals.
7.Ammonia or other gaseous fumes, extremely dusty conditions as well as strongly varying levels of humidity and/or room temperature can have a negative effect on the performance of the system, leading to a deterioration of the copy quality.
7
