5. Pattern mode
Editing motion sequence
data
You can edit the motion sequence of each part or the effect mo- tion sequence. The data can be edited in units of individual steps.
Selecting a motion sequence
Motion Dest. PCh (Pitch)...tin (Time)
1.Select the pattern that contains the motion sequence data you wish to edit.
2.Use the cursor keys [▲][▼] to make the parameter select LED indicate Motion Dest.
3.Rotate the dial to select the parameter that you wish to edit.
For PCh (Pitch/Speed), LEU (Level), FLt (filter), and PAn (Pan), only one parameter is valid for each part.
EFF (Effect), roL (Roll), and rEU (Reverse) are valid for each part.
Ed1 (Edit 1), Ed2 (Edit 2), dPt (Depth), and tin (Time) are valid for the pattern (all parts).
3.Press a part key to select the part that you wish to edit.
4.Press a step key to select the step that you wish to edit. The steps of a pattern whose length is two or greater can be se- lected successively by pressing the Select key.
5.Rotate the dial to edit the parameter value at that step. If the display indicates “diS,” the motion sequence does not apply to that step.
5
1
3
4
1,3 |
For Pitch, Filter, Level, and Pan motion sequences, using Motion Dest. to change the parameter and editing will cause all values to be initialized to “diS.”
If you move to another pattern without writing the edited motion sequence, it will revert to the state of the original motion sequence. If you wish to keep the edited motion sequence, you must perform the Write operation (☞p.47 “Saving a pattern”).
2
Editing the parameter values of a
motion sequence |
|
|
Motion Value |
|
|
PCh (Pitch/Speed) dis, | ...63 | |
LEU (Level) | dis, 0... | 127 |
FLt (filter) | dis, 0... | 127 |
Pan (Pan) | dis, L.64... | r.63 |
EFF (Effect) | dis, oFF... | on |
roL (Roll) | dis, oFF... | on |
rEU (Reverse) | dis, oFF... | on |
Ed1 (Edit 1) | dis, 0... | 127 |
Ed2 (Edit 2) | dis, 0... | 127 |
dPt (Depth) | dis, 0... | 127 |
tin (Time) | dis, 0... | 127 |
1.Use the cursor keys [▲][▼] to make the parameter select LED indicate Motion Value.
2.The display will alternately show the parameter name you selected in the preceding “Selecting a motion sequence,” and the value of the parameter.
While editing a motion sequence, it is not possible to use the step keys to switch steps on/off.
Depending on the part, some parameters cannot be se- lected.
While recording a motion sequence, the display will indi- cate “rEC,” and it will not be possible to edit a motion sequence.
While editing a motion sequence, the Rec key has no effect.
5. Pattern mode
45
