Kramer Electronics VP-724xl, VP-723xl, VP-720xl Connecting your Presentation Switcher / Scaler

Connecting your Presentation Switcher / Scaler

6 Connecting your Presentation Switcher / Scaler

To connect the VP-724xlfor example1 (see Figure 9), do the following2:

1.Connect one or more of the following video sources:

￿￿2 composite video sources: “AV Source 1” and “AV Source 2”, to the RCA connectors AV1 and AV2, respectively

￿￿2 s-Video sources: “s-Video Source 1” and “s-Video Source 2”, to the 4p connectors, YC1 and YC2, respectively

￿￿A component video3 source, for example, a “Betacam VCR”, to the 3 RCA connectors, Y, Pb/Cb, and Pr/Cr4

￿￿2 VGA graphics sources5: “VGA Graphics Source 1” and “VGA Graphics Source 2”, to the HD15 connectors VGA 1 and VGA 2, respectively

￿￿A DVI graphics source, to the DVI connector

2.Connect the stereo audio sources6 (not illustrated in Figure 9):

￿￿The audio of “CV Source 1” and “CV Source 2” to the AUDIO IN AV1 and AV2 terminal block connectors, respectively

￿￿The audio of “s-Video 1” and “s-Video 2” to the AUDIO IN YC1 and YC2 terminal block connectors, respectively

￿￿The audio of the component video source, the “Betacam VCR”, to the AUDIO IN COMP terminal block connector

￿￿The audio of the “DVI Graphics Source ” to the AUDIO IN DVI terminal block connector

￿￿The audio of “VGA Graphics Source 1” and “VGA Graphics Source 2” to the AUDIO IN VGA1 and VGA 2 terminal block connectors, respectively

3.Connect the “VIDEO OUT 1” and “VIDEO OUT 2” HD15F connectors7 to the video acceptors, for example, a Plasma monitor and a VGA monitor.

1 From this section on, all the information is relevant to the VP-719xl, VP-720xl, VP-723xl and VP-724xl machines, unless noted otherwise

2 Switch OFF the power on each device before connecting it to your VP-724xl. After connecting your VP-724xl, switch on its power and then switch on the power on each device

3 Sometimes called YUV, or Y, B-Y, R-Y, or Y, Pb, Pr

4 Alternatively, you can connect an RGB signal (not shown in Figure 9), as follows: Red to the Y connector, Green to the Pb/Cb connector, and Blue to the Pr/Cr connector

5 Available only on the VP-724xl, other models in this series have only one VGA graphic source 6 As required. Not all devices need to be connected

7 In the HDTV mode, the signal goes out via 3 PINS: PIN 1 is Red or Pr, PIN 2 is Green or Y, PIN 3 is Blue or Pb

13