Operating Your SDI Video Matrix Switcher

The MATRIX Display shows the identical 2 non-blinking digits (representing that input number) for all outputs.

7.2.3Clearing1 Outputs

You can clear (delete):

￿One output (see section 7￿ .2.3.1)

￿Several outputs (see section 7￿ .2.3.2)

￿All outputs (see section 7￿ .2.3.3)

7.2.3.1 Clearing One Output

To clear an output (in the AT ONCE mode):

1.Press the appropriate OUT button.

The MATRIX Display shows the 2 blinking digits, representing the present input number for that specific output2. If the present input is clear, the 2 blinking digits 00 appear in the MATRIX Display.

The STATUS Display shows the message:

out # x

Where x is the output number

2.Press the OFF button3.

The input is cleared and the MATRIX Display does not show any Input # in its place.

The STATUS Display momentarily shows the message:

out # x

reset

Where x is the output number

To clear an output (in the CONFIRM mode (the TAKE LED is lit)):

1.Repeat step 1 above.

2.Press the OFF button3.

The MATRIX Display shows the 2 blinking digits 00 instead of the previous 2 blinking digits and the TAKE LED blinks.

The STATUS Display shows4 the message:

out # x

reset

1 “Clearing” means disconnecting the output from any of the inputs, and leaving it disconnected

2 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9 3 You can press the OFF button first, and then an OUT button (the order is irrelevant)

4 Continuously, within the limit of the timeout (approximately 30 seconds)

23

Page 27
Image 27
Kramer Electronics VS-1616SDI user manual Out # Reset