Kramer Electronics VS-1616SDI Ready for receiving Start transmission from PC, Program replaced

Upgrading Flash Memory

10.After a few seconds the FLASH memory is erased and the MATRIX Display shows the following message:

Ready for receiving

Start transmission from PC

Note: If upgrading the firmware on more than one VS-1616SDI unit, be sure to perform the above steps, 5 to 9, on each VS-1616SDI unit before continuing.

11.From your PC’s K-Senderprogram, click the Send button.

The color of the Send button changes to red and numbers appear dynamically inside the blue line. The Displays on the VS-1616SDIshow the messages:

Transfer may take minutes	￿=0807561
Please, wait…

12.Observe the PC monitor and the VS-1616SDIMATRIX and STATUS Displays. After about 30 seconds, the program installation completes, the color of the Send button ceases to be red and the numbers inside the blue line disappear. The Displays on the VS-1616SDIshow the messages:

Program replaced	￿=16608D
successfully!	16608D

13. After about 3 seconds, the Displays show the messages:

Turn unit OFF, reconnect	￿=16608D
cables and turn ON	16608D

14.Verify that the checksum (for example, ￿=16608D) is the same on both lines.

If not, repeat the firmware upgrade process from the beginning.

15.You have successfully replaced the previous program and upgraded to the latest Kramer firmware version.

Turn the POWER switch on the VS-1616SDIoff.

Reconnect the RS-232 IN and RS-232 OUT rear panel port connections (as applicable).

Turn the POWER switch on the VS-1616SDIon again.

Observe the new version number that shows in the STATUS Display. Go to the Menu and restore your specific settings. Prepare and store all necessary setups.

1 Shows the dynamic progress upgrade of the checksum

42 KRAMER: SIMPLE CREATIVE TECHNOLOGY