Operating Your SDI Video Matrix Switcher

Where x is the output number

3.Press the TAKE button to confirm the action.

The input is cleared and the TAKE LED lights. The MATRIX Display does not show any Input # in its place.

7.2.3.2Clearing Several Outputs

To clear several outputs (in the AT ONCE mode):

1.Press the appropriate OUT button.

The MATRIX Display shows the 2 blinking digits, representing the present input number for that specific output1. If the present output is clear, the 2 blinking digits 00 appear in the MATRIX Display.

The STATUS Display shows the message:

out # x

Where x is the output number

2.Press the OFF button.

The output is cleared and the MATRIX Display does not show any Input # in its place.

The STATUS Display momentarily shows the message:

out # x

reset

Where x is the output number

To clear several outputs (in the CONFIRM mode (the TAKE LED is lit)):

1.Repeat step 1 above.

2.Press the OFF button.

The MATRIX Display shows the 2 blinking digits 00 instead of the previous 2 blinking digits and the TAKE LED blinks.

The STATUS Display shows1 the message:

out # x

reset

Where x is the output number

3.Press the second appropriate OUT button, by repeating step 1 above.

4.Repeat step 2 above.

5.Continue with this OUT-OFF button sequence, pressing the appropriate OUT buttons and the OFF, as required.

1 For example, pressing OUT button 9 shows the blinking digits 01 if input 1 was previously routed to OUT 9

24

KRAMER: SIMPLE CREATIVE TECHNOLOGY

 

Page 28
Image 28
Kramer Electronics VS-1616SDI user manual Clearing Several Outputs