Kuhn Rikon 3100 Lubrication Locations, shields removed for illustrative purposes

3100ST 006046 010507

LUBRICATION

ALWAYS STOP MIXER AND DISCONNECT POWER BEFORE SERVICING, REPAIRING OR CLEANING. USE SAFE SHOP PROCEDURES AND EXERCISE CAUTION WHEN WORKING ON THIS MIXER!

It is extremely important that the following lubrication guide be followed:

For lubricating bearings, use a good quality multipurpose grease. Replace all damaged or missing grease zerks immediately. Always clean zerks before using grease gun. Pump the grease in slowly until a slight bead forms around the bearing seals. Once a month check lines and connections on grease banks for leaks.

Before operating a new mixer, the roller chains should be liberally lubricated and then the unit operated under a no-load condition. This break-in period will allow the roller chains to be thoroughly lubricated and thus minimize heat-up during operation.

The large drive enclosure is designed to be used as an oil bath. Fill front enclosure until the oil level reaches the plug labeled “oil level ”on the enclosure.

LUBRICATION LOCATIONS 3115

* * * shields removed for illustrative purposes

28 © Copyright 2004 Kuhn Knight, Inc. Back to Table of Contents