La Pavoni P180 manual Hydraulic Diagram, Hydraulic Connection, Payment System Connection

HYDRAULIC DIAGRAM

HYDRAULIC CONNECTION

IMPORTANT: THE MANUFACTURER RECOMMENDS THE INSTALLATION OF A DESCALING FILTER, THEREFORE HE WILL NOT ACCEPT RESPONSI- BILITY FOR ANY DAMAGE CAUSED BY SCALE.

The machine can be installed as follows:

Table top installation:

Connect the mains pipe to the in-let electrovalve.

Check the pressure by the manometer, if it is over 1 bar, adjust it with the inside reducer.

Cabinet installation:

Place the machine on the cabinet, insert the pipe with the filter, the one-way valve and the float into the 15lt tank and the grey pipe into the 5 lt waste tank.

In order to discharge the coffee pucks into a bag, fix it up to the cabinet conveyer with the special hook and insert the chute under the espresso brewer.

Finally screw the machine on the cabinet.

PAYMENT SYSTEM CONNECTION

￿	12V PARALLEL	connect to keyboard connector COIN12V (see picture
	at page 7).
￿	24V PARALLEL	connect to keyboard connector COIN24V (see picture
	at page 7).
￿	EXECUTIVE / MDB	connect to the relative cables (optional)

After the payment system connection, you must set the kind of payment system in programming (see at page 15).

Pag. 28 Pag. 5