Land Pride RCR2584 manual Deck Attitude Adjustment, Lift-Type, Trail-Type, Table of Contents

Land Pride

Section 3 Adjustments

Table of Contents

Deck Attitude Adjustment

Refer to Figure 3-7:

This adjustment is very important. With the deck posi- tioned at this attitude, the blades will be cutting material only at the front of the cutter. If the deck is level, or the rear of the cutter is lower than the front, the blades are subject to continuous material flow which results in additional blade wear and horsepower loss as well as more frequent blade sharpening.

Lift-Type

1.Place tractor and mower on level surface.

2.Raise the mower to approximate desired cutting height with tractor hydraulic lever.

3.Loosen and remove bolts on adjusting brackets and position tailwheel.

4.Lower the cutter slowly until mower is 1” lower at front than at rear. Set stop on tractor lift quadrant so the cut- ter can be returned to same height.

5.Adjust top link. Refer to Figure 3-2.

Trail-Type

1.Place tractor and mower on level surface.

2.Retract ratchet jack or hydraulic cylinder to raise rear wheels off of ground.

3.Remove clevis pins from level rod assembly and axle.

4.Unscrew (only) short level rod weldment from level rod assembly approximately 1/4”, and reassemble to axle weldment.

	Best Deck Attitude for Cutting
14392
	Figure 3-7

7/14/08 RCR2584 Rotary Cutter 312-459M 19