Land Pride | Table of Contents |
Section 1 Assembly and Setup
Trail-Type Tractor Hook-Up
Refer to Figure
1.In hooking up the cutter, maintain proper distance be- tween the drawbar hitch point and the end of the trac- tors PTO shaft. This distance is 14” for 540 RPM.
14628
PTO/Drawbar Relation
Figure
2.Locate the cutter on a flat level surface. Back the trac- tor to the cutter and secure the cutter to the tractor drawbar with a 1”
IMPORTANT: Parking jack use: Whenever using parking jack (#3) install lock pin through jack and tube bracket welded to tongue. Use jack to raise and lower tongue to connect to the tractor drawbar. When tongue is connected to tractor drawbar retract jack fully, remove pin and store jack as shown in Figure
NOTE: Always place jack foot on firm surface or place board under jack for support.
3.Attach (black) slide collar (#1) to tractor PTO. Twist the quick disconnect on the yoke and push it forward to engage the groove on the splined output shaft. Attach hydraulic hose (#2) to tractor hydraulic system.
14381
Trail-Type Tractor Hook-Up
Figure
7/14/08 | RCR2584 Rotary Cutter | 13 |