Copying
20
2
Copying from the Bypass TrayUse the bypass tray to copy onto OHP
transparencies, adhesive labels, trans-
lucent paper, postcards and copy pa-
per that cannot be loaded in the paper
trays.
Preparation
When the duplex unit is attached,
the default is [1 Sided→2 Sided].
When copying from the bypass
tray, select [1 Sided] for copying in
[Dup./Combine/Series] (for example
[1 Sided→1 Sided] or [2 Sided→1 Sid-
ed] ). You can change the initial set-
tings. See p.94 “Duplex Mode
Priority” .
Important
❒When paper larger than 433 mm in
size is used, the paper may become
wrinkled, may not be fed into the
machine, or may cause paper jams.
Note
❒If you do not use the standard size
copy paper or if you use special pa-
per, you should input vertical and
horizontal dimensions. See p.16
“Placing custom size originals”.
The sizes that you can input are as
follows:
*1 The range is 148–432 mm (5.8"–17")
when the booklet finisher is in-
stalled.
❒The machine can automatically de-
tect the following sizes as standard
size copy paper:
❒When copying on OHP transpar-
encies or paper heavier than 128
g/m2 (about 34 lb.), you need to
specify the paper type. See p.22
“When copying onto special pa-
per” .
❒The maximum number of sheets
you can load at the same time de-
pends on paper type. The maxi-
mum number of sheets should not
exceed the upper limit.
AOpen the bypass tray.
Metric
version
• Vertical: 100–297 mm
• Horizontal: 148–600 mm *1
Inch
version
• Vertical: 3.9"–11.6"
• Horizontal: 5.8"–23.4” *1
Metric
version
A3L, A4KL, A5KL,
81/2" × 13"L
Inch
version
A3L, 11" × 17"L,
81/2" × 11"KL, 51/2" ×81/2"L
ZDSH110J