
IAC-F848
Super IO Device:
Onboard FDD Controller : Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you want to use it. If you install
Onboard Serial Port 1 / Port 2 : Select an address and corresponding interrupt for the first and second serial ports. The settings are “3F8/IRQ4”, “2E8/IRQ3”, “3E8/IRQ4”, “2F8/IRQ3”, “Disabled”, “Auto”.
UART Mode Select : This item allows you to select which mode for the Onboard Serial Port 2. The settings are Normal, IrDA, ASKIR and SCR
UR2 Duplex Mode: This item allows you to select the IR half/full duplex function.
Onboard Parallel Port : This item allows you to determine onboard parallel port controller I/O address setting. The settings are “378H/IRQ7”, “278H/IRQ5”, “3BC/IRQ7”, “Disabled”.
Parallel Port Mode: Select an operating mode for the onboard parallel (printer) port. Select “Normal”, “Compatible”, or “SPP” unless you are certain your hardware and software both support one of the other available modes.
ECP Mode Use DMA: Select a DMA channel for the parallel port for use during ECP mode. The settings are “3” and “1”.
3.6 POWER MANAGEMENT SETUP
When you select the “POWER MANAGEMENT SETUP” on the main program, the screen display will appears as:
Power Management Setup Screen
29