Lantronix XPress DR+ Configuration Using Telnet or Serial Port Setup Mode, Accessing Setup Mode

Chapter 7: Configuration Using Telnet or Serial Port (Setup Mode)

As an alternative to using a web browser, as described in the previous chapter, you can use the following procedures remotely or locally:

‹Use a Telnet connection to configure the unit over the network.

‹Use a terminal or terminal emulation program to access the serial port locally. The series of prompts at which you enter configuration settings is called Setup Mode.

Note: Detailed information about other setup methods is available from Lantronix Technical Support (http://www.lantronix.com/support).

The unit’s configuration is stored in nonvolatile memory and is retained without power.

This chapter tells you how to access Setup Mode and the general procedure for using it. To complete the configuration, continue with Chapter 8: Setup Mode: Server Configuration, Chapter 9: Setup Mode: Channel Configuration, and Chapter 10: Setup Mode: Advanced Settings.

Notes:

‹The menus in the configuration chapters show a typical device. Your device may have different configuration options.

‹For the latest firmware, release notes, and user documentation, go to the Lantronix web site (www.lantronix.com).

‹To use Telnet for communication to an XPress DR+W over a wireless network, you must first configure the network and WLAN settings using a serial connection. See Chapter 4: XPress DR+W.

Accessing Setup Mode

Telnet Connection

To configure the unit over the network, establish a Telnet connection to port 9999.

Note: You can also use DeviceInstaller to access Telnet. Select the device from the main window list, and click the Telnet Configuration tab. Skip steps 1 and 2 below.

XPress DR+ User Guide 63