Lantronix manual XPress DR+ Front Panel, Installation and Hardware

Chapter 3: Installation and Hardware

Figure 3-1. Typical Configuration

1.Connect a serial device to your XPress DR+. (See Serial Interface on page 20 for cable and connector specifications.)

2.Connect an Ethernet cable to the Ethernet port. (See Ethernet Interface on page 23.)

3.Supply power to your XPress DR+ using a 9-30 VDC or 9-24 VAC (2.3W maximum) source. (See Power Requirements on page 24.)

4.Supply power to the serial device.

Note: Connecting a device to an active Ethernet network can disrupt communications on the network. Make sure the device is configured for your application before connecting it to an active network

XPress DR+ Front Panel

The following figure illustrates the screw block connector pinouts and other components of the XPress DR+.

Note: For a description of the XPress DR+W front panel, see Chapter 4: XPress DR+W.

XPress DR+ User Guide 19