Lantronix manual Network Mode XPress DR+W only, Set Gateway IP Address, Options Bit, Value

Chapter 4: XPress DR+W

Network Mode (XPress DR+W only)

The first prompt requires you to set the unit for wired or wireless use. Wireless is the default, so just press Enter at the prompt.

Figure 4-7. Network Mode

The IP Address, Set Gateway IP Address, and Netmask fields display the current values.

Figure 4-8. Server Settings

IP Address : (000) .(000) .(000) .(000)

Set Gateway IP Address (N)

Netmask: Number of Bits for Host Part (0=default) (0)

Change telnet config password (N)

IP Address

If DHCP is not used to assign IP addresses, enter the IP address manually. The IP address must be set to a unique value in the network. Enter each octet and press Enter between each section. The current value displays in parentheses.

IP Address : (000) (000) (000) (000) _

If DHCP is used, the third octet of the IP address sets the BootP/DHCP/AutoIP options. The following table shows the bits you can manually configure to force the XPress DR+ to disable AutoIP, DHCP, or BootP. To disable an option, set the appropriate bit.

Table 4-2. BootP/DHCP/AutoIP options

Options	Bit
AutoIP	0
DHCP	1
BootP	2

Value

1

2

4

For example, if the third octet is 0.0.5.0, the AutoIP and BootP options are disabled; only DHCP is enabled. (The value 5 results from adding the binary equivalents of 0 and 2.) This is the most common setting when using DHCP.

Set Gateway IP Address

The gateway address, or router, allows communication to other LAN segments. The gateway address should be the IP address of the router connected to the same LAN segment as the unit. The gateway address must be within the local network. The default setting is N (No), meaning the gateway address has not been set. To set the gateway address, type Y and enter the address.

Set Gateway IP Address (N) ? Y

Gateway IP addr (000) (000) (000) (000) _

XPress DR+ User Guide 34