Lantronix XPress DR+ manual Channel, Port Settings

Chapter 6: Configuration Using Web Manager

Figure 6-5. Channel Serial Settings

2. In the available fields, enter the following information:

Channel 1

Disable Serial Port

When selected, disables communication through the serial port. The serial port is enabled by default.

Port Settings

Protocol	From the drop-down menu, select the protocol type for the
	selected channel. The default setting is RS232.
	Note: Configuring RS-485 is not permitted.
Flow Control	Flow control manages data flow between devices in a network
	to ensure the data is processed efficiently. Too much data
	arriving before a device is prepared to manage it causes lost
	or retransmitted data. None is the default setting.
Baud Rate	The unit and attached serial device, such as a modem, must
	agree on a speed or baud rate to use for the serial connection.
	Valid baud rates are 300, 600, 1200, 2400, 4800, 9600
	(default), 19200, 38400, 57600, 115200, or 230400.
Data Bits	Indicates the number of bits in a transmitted data package.
	The default setting is 8.
Parity	Checks for the parity bit. The default setting is None.
Stop Bits	The stop bit follows the data and parity bits in serial
	communication. It indicates the end of transmission. The
	default setting is 1.

XPress DR+ User Guide 52