Lantronix XPress DR+ manual Connection Settings UDP, Common Options, Disconnect Mode

		Chapter 6: Configuration Using Web Manager
Common Options
	Telnet Mode	This field is available for configuration only when Active
		Connect is set to None. Select Enable to permit Telnet
		communication to the XPress DR+.
	Terminal Name	This field is available for configuration only when Telnet Mode
		is set to Enable.
		Use the terminal name for the Telnet terminal type. Enter only
		one name. When this option is enabled, the unit also reacts to
		the end of record (EOR) and binary options, which can be
		used for applications such as terminal emulation to IBM hosts.
	Connect Response	A single character is transmitted to the serial port when there
		is a change in connection state. Default setting is None.
	Use Hostlist	If this option is set to True, the device server scrolls through
		the host list until it connects to a device listed in the host list
		table. Once it connects, the unit stops trying to connect to any
		others. If this connection fails, the unit continues to scroll
		through the table until it connects to another IP in the host list.
		The host list is disabled for Manual Mode and for Modem
		Mode. The unit will not accept a data connection from a
		remote device when the host list option is enabled.
	LED	Select Blink for the status LEDs to blink upon connection or
		None for no LED output. The default setting is Blink.
Disconnect Mode
	On Mdm_Ctrl_In Drop	Set to Yes for the network connection to or from the serial port
		to drop when modem_control_in transitions from a high state
		to a low state. The default setting is No.
	Hard Disconnect	When set to Yes, the TCP connection closes even if the
		remote site does not acknowledge the disconnect request.
	With EOT	Select Yes to drop the connection when Ctrl-Dor Hex 04 is
		detected. Both Telnet Mode and Disconnect with EOT must
		be enabled for Disconnect with EOT to function properly.
		Ctrl+D is only detected going from the serial port to the
		network. The default setting is No.
	Inactivity Timeout	Use this parameter to set an inactivity timeout. The unit drops
		the connection if there is no activity on the serial line before
		the set time expires. Enter time in the format mm:ss, where m
		is the number of minutes and s is the number of seconds. To
		disable the inactivity timeout, enter 00:00.

3.When finished, click the OK button.

4.To save and reboot, click Apply Settings on the main menu.

Connection Settings - UDP

To configure a channel’s UDP settings:

1.On the main menu, click Connection. The Connection Settings window for the selected channel displays.

2.In the available fields, enter or modify the following information:

XPress DR+ User Guide 56