Lantronix XPress DR+ manual Send the Escape Sequence +++ in Modem Mode, Auto Increment Source Port

Chapter 9: Setup Mode: Channel Configuration

Modem Mode	Function
Command

ATS0=n

ATEn

ATVn

Enables or disables connections from the network going to the serial port.

n=0 disables the ability to make a connection from the network to the serial port.

n=1-9 enables the ability to make a connection from the network to the serial port.

n>1-9 is invalid.

Enables or disables character echo and responses. n=0 disables character echo and responses.

n=1 enables character echo and responses.

Enables numeric response or full verbose. n=0 enables numeric response.

n=1 enables full verbose.

Note: The unit recognizes these AT commands as single commands such as ATE0 or ATV1; it does not recognize compound commands such as ATE0V.

Send the Escape Sequence (+++) in Modem Mode

Send ‘+++’ in Modem Mode (Y) ? _

Disable or enable the unit's ability to send the escape sequence. The default is Y (Yes) (send the escape sequence).

Auto Increment Source Port

Auto increment source port (N) ? _

Y (Yes) auto increments the source port. The XPress DR+ increments the port number used with each new connection.

Remote IP Address

This is the destination IP address used with an outgoing connection.

Remote IP Address : (000) (000) (000) (000) _

Note: This option does not display when Hostlist is enabled from the ConnectMode prompt (see Connect Mode on page 72 for more information).

XPress DR+ User Guide 78