Lincoln Electric IM528-B manual Ranger 8 Operation, K930- / Ranger 8 Without the K892-1 Settings

OPERATION

RANGER 8 OPERATION

The tables (Table 8 & 9) list the recommended switch and control settings for the TIG Module/Ranger 8 combination. The first table is for the Ranger 8, and the second for the Ranger 8 with the K892-1 Remote Kit installed.

Operate the Ranger 8 in accordance with the Ranger 8 Manual.

Note: For AC TIG welding, the maximum TIG welding output currents on each range setting will be approximately 50% higher that those marked on the nameplate. This is due to the special nature of the AC TIG welding arc. Do not AC TIG weld on the 225AC range setting. The output current may exceed the rating of the Ranger 8.

TABLE 8: K930-[ ] / RANGER 8 (WITHOUT THE K892-1) SETTINGS

K930-[ ] SETTINGS

			HF		2		A
								CURRENT
			HIGH			CURRENT		CONTROL
POWER		FREQUENCY		AFTERFLOW		CONTROL		SWITCH
	ON			ADJUST		SETTING HAS
				TO SUIT,		NO EFFECT
				5 - 55 SECONDS		ON OUTPUT		SETTING HAS
			START					NO EFFECT
			- OR -					ON OUTPUT

CONTINUOUS

RANGER 8 (WITHOUT THE K892-1 REMOTE KIT) SETTINGS

			RANGE	CONTROL
IDLER
SWITCH
	STICK/TIG
	POLARITY
			SELECT TO SUIT,
		DC-	50 - 210
				SET FOR
HIGH				DESIRED OUTPUT
			SELECT TO SUIT,	CURRENT
		AC	50-175

TIG MODULE – 23 –