ACCESSORIES
OPTIONS / ACCESSORIES
The following field installed Kits and accessories may be used dependingon the application:
K936 Control Cables
At least one of the following control cables is needed to connect the TIG Module to the power source. Four different cables are available. The proper choice of cable depends on the power source being used. See the installation section to choose the proper control cable. The control cable carries one or more of the following circuits between the TIG Module and the power source: Input power, remote control signals, contactor control signals, and ground.
K937 Control Cables Extensions
Control cable extensions are available in 22 and 45 foot engths. These allow the TIG Module to be operated at distances up to 200 feet from the power source. The extensions connect between the standard control cable and the TIG Module.
K938-1 Contactor Kit
This field installed kit must be installed in the TIG Module whenever it is used with a power source which does not have a
K844-1 Water Valve Kit
A field installed kit which contains one water valve for mounting inside the TIG Module. The water valve is controlled by the same preflow and afterflow timers as the gas valve.
Other Compatible Lincoln Accessories:
K963 Hand Amptrol
K870 Foot Amptrol
K814 Arc Start Switch
All Magnum TIG torches and accessories
Compatible Equipment
The TIG Module can be used with the following Lincoln power sources:
Ranger 81
Ranger 9
Ranger 101
Ranger
including “I” versions1
Idealarc 250 AC/DC1
Weldanpower 1501
Weldanpower 150 AC/DC1
Weldanpower G80001
SA 250 Perkins1
SAE 350 Deutz1
SAE 4001
Classic I1,2
Classic II1
Classic III & IIID1
1Requires the
For installation of field installed accessories see the
INSTALLATION SECTION.
K939-1 Docking Kit
The Docking Kit provides a means to “dock” the TIG Module on top of a
TIG MODULE | – 31 – |