Leica MZ16 A Transmitted-light stand, bright field, 20 W, Follow the safety instructions given on

Transmitted-light stand, bright field, 20 W

Follow the safety instructions given on page 7.

￿Fit the side-faced column to the transmitted-light base as described on page 23.

Fitting the bulb

Never touch the bulb when it is hot. You may sustain burns.

•Do not touch the new 6 V/20 W halogen bulb directly with your fingers, because finger marks can cause it to crack when heated.

Remove finger marks immediately with a cloth dipped in pure alcohol.

￿Insert the slider together with the

bulb socket.

￿ Hold the new bulb in a cloth and push it into position.

￿ Push the slider carefully but complete- ly back along the rail to the stop.

Filters • The transmitted-light stand contains a KG1 filter.

• You can insert other ∅ 50 mm filters if you need them:

￿Pull out the slider.

￿Insert the ∅ 50 mm filter.

￿Push the slider carefully but

completely back along the rail to the stop.

Starting up The ex-factory setting of the voltage selector is 230 (for volt- ages between 200–240 V) and the fuse holder contains two 160 mAT fuses.

For 100–120 V power supply:

￿ Set the voltage selector to 115.

￿Fit the enclosed two 315 mAt fuses in the fuse holder instead of the two 160 mAT fuses (see the section "Changing fuses" on the right).

￿Connect the power cable to the socket of the base and to the power source.

24 Leica M Stereomicroscopes – Assembly