Changing fuses Use:

Two 160 mAT fuses for voltages between 200–240 V.

Two 315 mAT fuses for voltages between 100–120 V (see the section "Starting up" on the left).

￿ Disconnect the power cable from the stand. ￿ Pull out the fuse holder.

￿Fuse at rear: Press out downwards.

￿Spare fuse at front: Pull out sideways and

insert into holder at rear.

￿Push the fuse holder back into position.

Transmitted or On the rear side of the base, there is a incident light socket for incident lamps of up to 20 W.

Connect an incident lamp to the trans- mitted-light stand, if required.

• Either transmitted light or incident light can be switched on.

￿For transmitted light: Switch in position I.

￿For incident light: Switch in position II.

￿Use thumb wheel to adjust brightness.

Switching on the ￿ On the rear of the stand: Use the thumb transformer wheel to switch on the transformer and

to adjust the brightness.

Disconnection from ￿ Remove the power cable from the power socket. mains power supply

Transmitted light ￿ Switch on transmitted light.

Transmitted light, Bright field is suitable for examining translucent objects featur- bright field ing contrasting structures. The object is directly illuminated

from below and is seen in its natural colors against a bright background.

￿For transmitted light, bright field:

Pull lever forwards.

Inclined Inclined transmitted light which traverses the object obliquely transmitted light will produce effects advantageous for observing small translu-

cent objects such as foraminifera and fish eggs.

￿Move the lever slowly towards the column of the stand until the desired effect is obtained.

Leica M Stereomicroscopes – Assembly

25

Page 25
Image 25
Leica MS5, MZ16 A, MZ6, MZ125, MZ16 FA, MZ95, MZ75 user manual Changing fuses Use, Two 160 mAT fuses for voltages between 200-240