Quick way to start with the TPS400 Mining Programs | Leica specification

The quick way to start with the TPS400 Mining Programs.

To use equipment in the permitted manner, please refer to the detailed safety instructions in the TPS400 User Manual (English version).

© 2003 Leica Geosystems AG Heerbrugg, ® All rights reserved.

TPS400 Mining Manual-1.0.0en

2

The quick way to start

Image 2

Leica user manual Quick way to start with the TPS400 Mining Programs

Contents

TPS400 Series Quick way to start with the TPS400 Mining Programs Contents Overview Contents Introduction How to use this manualSymbols used in the sequence of operation Known Unknown Peg SurveyIntroduction Data uploading using Mining Editor Before starting Peg Survey Start and execution Peg Survey Step Valid coords Error messagesStation or BS point has no Number of sets Measure Backsight Point Proceeding Peg SurveySequence Set 1 of total Measure or DIST/REC Exit Repeat and until all sets are measured DHD ResultsDHz MHz MHDBS/FS Average Residual Results Saving dataResult Coordinates foresight point Front Line Peg Grades Known Start and execution Grades Slope gradient explained Gradeline Marking Height difference dHgt and horizontal distance dHD explained Grades Result Measurement dataPoint Offset Start and execution Offset Start and execution Offset Saving data Offset information Polar setout Setting outSetting out coordinates from memory Procedure Orthogonal setout Cartesian setout Result is displayed Tie DistanceRadial Method Determine second target Polygonal Method Softkeys polygonal method Softkeys radial method Mining Editor Installation on the PCProgram content Mining Editor Example1 Practical ExamplesDefine and upload Tolerances Example2 Creating fixpoint files Define tolerances File ! Save As File ! Open Second Example Importing of fixpoints in Ascii format Process import fixpoint files ISO standard