Important notice, Installation

This unit has been produced according to all current safety regulations. The following safety tips should safeguard users against careless use and the dangers connected with such use.

Every electrical appliance can have a defect despite careful and thorough manufacturing. If you detect smoke development or an exceptionally strong build-up of heat, then pull out the power plug immediately.

Ensure that the unit is sufficiently ventilated! Never place next to or underneath curtains!

Only plug flex into 230V/50Hz. Do not plug into any other voltage.

The apparatus must be connected to a main socket outlet with a protective earthing connection.

The socket-outlet must be installed near the equipment and easily accessible.

Make sure that an expert carries out any repairs.

Do not open unit. Your own attempts to repair the unit could result in a fire.

Keep away from rodents. Rodents (and also cockatiels) enjoy biting into electric flexes. The animal can cause a short cut (fire hazard!) and receive a fatal electric shock.

Always hold plug when pulling out plug from power mains supply system. Do not pull on flex. The flex can become overloaded and cause a short cut.

Never wet clean. Only use a damp cloth, the same as when cleaning furniture.

Do not submerge in or under water!

Set up unit so that no one is able to trip over the flex.

Only use the unit on a stable, shock-free base in order to avoid any danger from falling.

Take note that toddlers can pull the unit down from the table or cupboard by means of its flex. Children can hurt themselves when doing this.

Do not use the unit near heat sources. The casing and flex could be damaged by the impact of heat.

Watch out for kiddies copying what adults do! Do not stick any objects through the vents!

The vents must remain open! No newspapers or covers should be put on the unit!

The remote control is not a toy! Toddlers could swallow the batteries. If a battery has been swallowed, please seek out a doctor immediately.

The screen is made of glass and can break if damage is done to it. Be careful when collecting sharp-edged glass splitters. You could be hurt or the unit could be damaged.

If the unit is mounted on the wall, contact the shop where you purchased the unit for advice, and leave the installation work to experts. Incomplete installation work can cause you injuries.

When installing the set on a wall, allow at least 6 cm clearance between the rear of the set and the wall. Clearance of less than 6 cm will obstruct the vents and cause the interior of the set to overheat, resulting in faults or damage to the set.

Taking fall-prevention measures

-If these measures are not taken, the unit can fall and you could be injured.

-Contact the shop where you purchased the unit to obtain full details of the measures.

When a TV stand is used,

-Ensure the unit is fully on the stand and placed in the centre.

-Do not leave the stand doors open.

-You could be hurt as a result of the unit falling or breaking, or your fingers being caught or jammed. Take extra precautions if you have children.

Attention!

Cleaning instructions for your Plasma TV.

Safety note:

Before you start to clean, switch the set's power off completely and disconnect the plug from the mains power supply.

Be careful not to scratch the plastic coated front panel - it is highly vulnerable to accidental scratching (e.g. by fingernails or other sharp items). While cleaning, do not wear jewelry that could cause surface scratching (such as rings, wrist-watch, etc.). Use a lint-free cloth and pure water to clean with, but make sure the cloth is thoroughly wrung out so that it is just damp and not soaking wet - also make sure that the cloth is free from any dirt that could cause scratching to the surface.

Wipe the set clean using minimal pressure.

Do not use standard window cleaning fluid. Its alcohol / ammonia will dissolve the front window’s coating.

Never use solvent or thinner. Never use special cleaners which are designed for cleaning PC Monitors or CRT TVs. Finally carefully rub dry with a clean dry lint-free cloth.

Do not use paper towels or tissues to clean the set - paper can disintegrate when wet or may leave a trail of dust behind. Some paper can also be abrasive and scratch your screen.

Please pay attention to the following instructions in order to avoid receiving a life-threatening electric shock:

Protect against moisture. Never use in the bath or sauna.

Never use near a bath, shower or swimming pool.

Never use the unit if it has got wet. This can also mean condensation moisture, which occurs in the winter when the cold unit is brought into a heated flat. Wait before operating the unit especially after it has been transported in the winter, until the cold unit has adjusted to the room temperature.

Do not place any heavy objects on the flex. Electrical isolation could be damaged.

Never wrap insulating tape around damaged flexes or on damaged plugs. These should be repaired by experts instead.

Never run a unit with a defect cabinet. Do not make provisional repairs, if a cabinet is damaged. This should be replaced by a new cabinet.

Unplug the unit from the mains power supply prior to the cleaning of the unit.

4

3U84011A [E] P02-10

4

20/12/05, 15:21

Page 4
Image 4
Lenco Marine PL 4201 operating instructions Important notice, Installation, Safety note