Lenovo 1983, 1993, 1995, 1986, 1985, 1987 Replacing the heat sink and fan assembly, What to do next

5.Lay the computer on its side and remove the four screws at the rear of the chassis that secure the power supply assembly.

Figure 30. Removing the screws for the power supply assembly

6.Slide the power supply assembly to the front of the computer and then lift it out of the chassis.

7.Ensure that the new power supply assembly is the correct replacement.

8.Install the new power supply assembly into the chassis so that the screw holes in the power supply assembly align with those in the chassis.

9.Install and tighten the four screws to secure the power supply assembly. Note: Use only screws provided by Lenovo.

10.Reconnect the power supply assembly cables to the system board and each of the drives.

11.Secure the power supply assembly cables with the cable clips and ties in the chassis.

What to do next:

•To work with another piece of hardware, go to the appropriate section.

•To complete the installation or replacement, go to “Completing the parts replacement” on page 61.

Replacing the heat sink and fan assembly

Attention:

Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.

This section provides instructions on how to replace the heat sink and fan assembly.

CAUTION:

The heat sink and fan assembly might be very hot. Turn off the computer and wait three to five minutes to let the computer cool before removing the computer cover.

Chapter 5. Installing or replacing hardware 45