8. Slide the new card reader into the drive bay until it snaps into position.
Figure 29. Installing the card reader
9.Reconnect the card reader cable to Front USB connector 2 on the system board. See “Locating parts on the system board” on page 12.
10.Reinstall the front bezel. See “Removing and reinstalling the front bezel” on page 35.
11.To complete the installation or replacement, go to “Completing the parts replacement” on page 86.
Replacing the battery
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.
Your computer has a special type of memory that maintains the date, time, and settings for
The battery normally requires no charging or maintenance throughout its life; however, no battery lasts forever. If the battery fails, the date, time, and configuration information (including passwords) are lost. An error message is displayed when you turn on the computer.
Refer to the “Lithium battery notice” in the Safety and Warranty Guide for information about replacing and disposing of the battery.
To replace the battery, do the following:
1.Turn off the computer and disconnect all power cords from electrical outlets.
2.Remove the computer cover. See “Removing the computer cover” on page 34.
3.Locate the battery. See “Locating parts on the system board” on page 12.
