2.Locate the available SATA connector on the system board. See “Identifying parts on the system board” a pagina 7.

3.Connect one end of the signal cable to the drive and the other to the available SATA connector on the system board.

4.Locate one of the extra five-wire power connectors and connect it to the drive.

Figura 17. Connecting a serial ATA drive

What to do next:

vTo work with another option, go to the appropriate section.

vTo complete the installation, go to Capitolo 4, “Completing the parts replacement”, a pagina 31.

Installing a diskette drive in bay 3

To install a diskette drive in bay 3, do the following:

1.Remove the computer cover. See “Removing the cover” a pagina 9.

2.Access the system board. See “Accessing system board components and drives” a pagina 10.

3.Remove the metal shield from the diskette drive bay by using a flat-blade screwdriver to gently pry it loose.

4.Remove the plastic panel in the bezel by squeezing the plastic tabs that secure the panel on the inside of the bezel.

5.Install a retainer bracket on the side of the diskette drive.

Figura 18. Retaining bracket

6.Install the diskette drive into the bay from the front until it snaps into position.

Figura 19. Installing the diskette drive

18Hardware Installation and Replacement Guide

Page 26
Image 26
Lenovo 9159 manual Installing a diskette drive in bay