Level One Printer Servers
Problem No. 2
Solution No. 2
Problem No. 3
•If the printouts are the same, then the problem is NOT the LevelOne Printer Server. The problem might be that an incorrect printer driver was chosen or the timeout setting in the CAPTURE command is too short.
•If the printouts are NOT the same, there may be a problem with the LevelOne Printer Server. Call your dealer.
7.
•Disconnect the printer attached to LPT1 of your PC and connect it to your LevelOne Printer Server.
•For NetWare 2.x or 3.x, run PCONSOLE and Select Print Queue Information. Then select the LevelOne Printer Server's print queue and select Current Queue Status. Set Servers can service entries in queue to YES
•For NetWare 4.x bindery and NDS modes, run PCONSOLE and select Print Queues.
Then select the print queue and select Status.
Set Allow service by current print servers to YES.
My LevelOne Printer Server does not appear in the Active Device List of the PSConfig program.
•Ensure that the LevelOne Printer Server is on the same network segment as your PC.
•Load the NetBEUI protocol on your PC, so that PSConfig can try connecting using NetBEUI. Once connected, check the following:
•The NetWare protocol is enabled.
•The Ethernet frame type of your PC may be different than the one with your LevelOne Printer Server. Enable all Ethernet frame types.
My LevelOne Printer Server is configured as a Novell Print Server, and cannot log in to a file server.
Solution No. 3 The following steps may solve this problem:
1.Get the LevelOne Printer Server information using PSConfig. If the device is configured as a Novell Print Server, the information will look like the following:
Server Name: PS110049
NetWare Information:
Master File Server: ICE
Print Server Mode Status:
Your_File_Server: Current Status
Remote Printer Mode Status: N/A
2.Make sure the master file server name is assigned correctly.
3.Check the Current Status of Your_File_Server:
•Connected: No action required
•No file server: Assign a master file server using PSConfig
•Connecting to Server: Wait and check if the file server exists
- 82 -
