RV-8 Appendix C
C-15
4. If you wish to erase all the learned functions in the RV-8 remote,
press the ALL button and then press the SURE? button at the next
LCD screen.
5. To erase all the buttons in a single device or an individual button in
the device, press the DEVICE button.
6. Press the device button (TV, VCR, MAIN, etc.) to erase the
button(s) from the device.
Note:
Press the PAGE button and then press the DEVICE button (TV, VCR,
etc.) to erase the learned function in the device button itself.
7. Press the ALL button to erase all the learned buttons in the device
and press the SURE? button at the next LCD screen.
8. Press a single button to erase individual buttons one at a tim e. This
will show all th e functio ns in th e device. Pre ss the button yo u wish
to erase.

PROGRAMMING THE BACKLIGHT TO TURN OFF

The backlight can be toggled On and Off by pushing the LIGHT
button on the top right side of the remote. It can also be set to turn off
at a predetermined time.
To program the backlight:
1. Go to the SETUP mode by pressing the HOME and ENT buttons
simultaneously for three seconds.
2. Press the LIGHT button next to the LCD screen.
3. Using the number pad buttons, enter the desired backlight time
(in seconds). It can go up to 99 seconds. Save the time by pressing
the button to the right of the time just assigned.
4. Exit from the SETUP mode by pressing the HOME button.
Note:
The time entered in SETUP for the backlight to go off is extended each
time a button is pushed. The ligh t will tu rn off at the predetermined
interval after the last button has been pushed.

CLONING THE RV-8 REMOTE CONTRO L

To clone the remot e from anothe r remote:
1. Go to the SETUP mode by pressing the HOME and ENT buttons
simultaneously for three sec onds.
2. Press the CLONE button next to the LCD screen.
3. Press either the SEND or RECV button depending upon the role of
the remote control. If the RV-8 remote is to be copied from, press
the SEND button. If it is to be copied to, press the RECV button.
4. To clone the entire remote, press the ALL button. To clone only
one device at a time, press the DEVICE button.
5. Press the DEVICE button to show all of the devices. Press the
device button you wish to clone.
6. Set the RV -8 remote head-to-head with another RV -8 remote. Each
unit should be in either cloning from or cloning to mode, based
on the above steps.
7. Press the START button on both units to begin cloning. It will take
about 40 seconds to complete the cloning. The LCD will flash
“GOOD” upon completion.
8. Exit from the Cloning mode by pressing the HOME button and
then exit from the SETUP mode by pressing the HOME button
again.