Lexmark C770, C772 manual Supporting IPSec Internet Protocol Security, Using Secure mode

Administrative support

•No authentication and no encryption

•Authentication with no encryption

•Authentication and encryption

Note: Only the selected level and later may be used to communicate.

Supporting IPSec (Internet Protocol Security)

IP Security protocol provides authentication and encryption of communications at the network layer allowing all application and network communications over the IP protocol to be secure. IPSec can be set up between the printer and up to five hosts, using both IPv4 and IPv6. To configure IPSec through the Embedded Web Server:

1Open your Web browser. In the address line, enter the IP address of the printer you want to configure using the format: http://ip_address/.

2Click Configuration.

3Under Other Settings, click Network/Ports.

4Click IPSec.

Two types of authentication are supported for IPSec:

•Shared Key Authentication—Any ASCII phrase shared among all the participating hosts. This is the easiest way to configure when only a few hosts on the network use IPSec.

•Certificate Authentication—Allows any hosts or subnet of hosts to authenticate for IPSec. Each host must have a public/private key pair. Validate Peer Certificate is enabled by default, requiring each host to have a signed certificate and the authority certificate must be installed. Each host must have its identifier in the Subject Alternate Name of the signed certificate.

Note: After a device is configured for IPSec with a host, IPSec is required for any IP communication to take place.

Using Secure mode

You can configure the TCP and UDP ports to one of three modes:

•Disabled—Never allows network connections to this port.

•Secure and Unsecure—Allows the port to remain open, even in Secure mode.

•Unsecured Only—Allows the port to only open when the printer is not in Secure mode.

Note: A password must be set to enable Secure mode. Once enabled, only the ports set to Secure and Unsecure will be open.

To configure the Secure mode for TCP and UDP ports from the Embedded Web Server:

1Open your Web browser. In the address line, enter the IP address of the printer you want to configure using the format: http://ip_address/.

2Click Configuration.

3Under Other Settings, click Network/Ports.

4Click TCP/IP Port Access.

Note: Disabling ports will disable function on the printer.

Setting security using the Embedded Web Server (EWS)

82