Set Password

You can enter or change password.

1.Select [Set Password] option then press B.

2.Follow step 2 as shown [Rating].

To change the password, press ENTER when the [Change] option is highlighted, then input old pass- word. Input new password. Enter it again to verify. To delete the password, select [Delete] option then press ENTER, then input old password. The pass- word is deleted.

3.Press HOME to exit the menu.

If you forget your password

If you forget your password you can clear it using the following steps:

1.Press HOME and the Home menu appears.

2.Select [Setup] > [Start] and press ENTER.

3.Input the 6-digit number [210499]. The message appears, select [OK] then press ENTER. The security code is cleared.

4.Enter a new code as described above.

Area Code

Enter the Area Code whose standards were used to rate the DVD video disc, based on the list in the reference chapter (see page 52).

1.Select [Area Code] option then press B.

2.Follow step 2 as shown [Rating].

3.Select the first character using v / V buttons.

4.Shift the cursor using B buttons and select the second character using v / V buttons.

5.Press ENTER to confirm your area code selection, then press HOME to exit the menu.

Recording Settings

Disc Record Mode

You can set the picture quality for recording; XP (High Quality), SP (Standard Quality), LP (Low Quality), EP (Extend Quality), MLP (Maximum Long Play).

1.Select the [Disc Record Mode] option then press

B.

2.Use v / V to select a desired Disc Record Mode (XP, SP, LP, EP or MLP).

3.Press ENTER to confirm your selection, then press HOME to exit the menu.

DV Record Audio

You need to set this if you have a camcorder using 32kHz/12-bit sound connected to the front panel DV IN jack. Some digital camcorders have two stereo tracks for audio. One is recorded at the time of shoot- ing; the other is for overdubbing after shooting.

On the Audio 1 setting, the sound that was recorded while shooting is used. On the Audio 2 setting, the overdubbed sound is used.

Auto Chapter

During recording, chapter markers are added auto- matically at fixed intervals. You can set this interval to 5 minutes or 10 minutes. To turn off automatic chap- ter marking, select [None].

Note:

If [Disc Record Mode] option is set to [MLP], the [5 Min] option is not selectable.

24

Page 24
Image 24
LG Electronics DR787T owner manual Recording Settings